What size trolling motor should I use for a kayak?
Ideally, you need a minimum of two pounds of thrust per 100 pounds of weight you want to move. Most trolling motors are made for small boats, which means they have more than enough power to drive your kayak through the water. That said, power is still an important consideration because you don’t want too much.
How fast will a 55lb trolling motor go on a kayak?
Assuming perfect riding conditions, the use of the best fuel i.e. the distillate marine diesel, and moderate load, 55-pound trolling motors are likely to attain a maximum speed of only 5 miles per hour. This would take around two hours for the deep cycle battery charge to get completely depleted.
Is it worth putting a trolling motor on a kayak?
Adding a trolling motor to a kayak can make it easier and more fun. It can also give you the ability to bring gear that you wouldn’t otherwise be able to take with you. Luckily, adding a motor is not very difficult or expensive.
How deep should trolling motor be to kayak?
A trolling motor’s ideal propeller should be at a depth that keeps about 6 inches of water above the blades. In other words, the centerline of the motor and the prop shaft should be about 12-18 inches below the waterline, depending on the make, model and dimensions of the trolling motor.
Can you put an electric trolling motor on a kayak?
Trolling Motor. The most accessible way to motorize a kayak is by adding an electric trolling motor. For a few hundred bucks, an angler can install a 45-pound thrust trolling motor and 12-volt, deep-cycle marine battery on almost any kayak.
How long will a 100Ah battery run a trolling motor?
How long will a 100Ah battery run a trolling motor? A 100Ah lead acid deep-cycle battery will run a 30lbs thrust trolling motor on Speed 4 for 4 hours.
Will 2 trolling motors make you go faster?
Two motors in the back will just push the bow a little higher in the air, and the stern will dig in deeper, slowing you down. The boat will be faster with a trolling motor if it’s level in the water.
How fast can a 2.5 hp outboard go?
Tohatsu 2.5 Two-Stroke ($630; www.tohatsu.com) power: 2.5 hp weight: 26 pounds top speed: 5.4 mph noise at full throttle: 84 dB-A. The Tohatsu 2.5 was the only two-stroke we tested. As expected, it’s the lightest and least expensive.
Can you put a small motor on a kayak?
It is possible to put a motor on a kayak. Small trolling motors with a low HP (horse power) are needed as powerful engines will make the kayak difficult to control and too stern heavy. Electric trolling motors work the best with kayaks because they are lightweight and do not require fuel to be stored onboard.
How long should a kayak trolling motor be?
Choosing the correct trolling motor shaft length is important so that the angler’s electric motor does not cavitate, creating fish-spooking noise. The rule of thumb is that the top of the motor section should be submerged 12″.
…
How do I select trolling motor shaft length?
| BOW TO WATERLINE | RECOMMENDED SHAFT LENGTH |
|---|---|
| 22″ – 28″ | 48″ – 52″ |
| 28″ – 44″ | 54″ – 72″ |
| 45″+ | 87″ |
Is a trolling motor enough for a river?
Most jon boat trolling motors come in 5 speeds and if you load 800 pounds into your boat you’ll be unable to use the first three speeds. The minimum I would recommend for even slow moving rivers (like the Danube) is 40-45lbs of thrust so you can actually make use of the lower speeds.