How do you clean a snorkel tube?
Typically, a bit of dish soap and warm water is all you would need. Resist the urge to use cleaners containing chlorine (like Bleach) as they will damage the gear and potentially cause cracks, fading, and other issues. Thoroughly clean, rinse, and dry the gear before storing.
How do you clean the inside of a snorkel?
Grab a bucket with warm water, throw in some detergent or soap, let it soak for a few minutes, thoroughly rub your fingers throughout the entire mask, and rinse off the dirty water and suds. Dry completely with a clean towel.
How do you clean a moldy snorkel?
Rinse the snorkel thoroughly and then soak for 30 minutes in a solution of bleach prepared as follows 1 tbsp of 5% household bleach mixed well in per gallon of cold water. Prolonged contact with the bleach solution is necessary to kill the mold.
How do you disinfect snorkel equipment?
To keep your snorkel clean and bacteria-free, you can use one of two methods. You can wash the snorkel in a bucket of fresh water and dish detergent, rinsing it clean under fresh water, or you can soak it in a bucket of diluted bleach for 30 minutes and then rinse under running water.
How do you disinfect a snorkel and mask?
Cleaning Snorkel and Fins
- Bleach and water. Dilute 1 Tablespoon bleach in a bucket of water and mix thoroughly. …
- Dish detergent and water. Mix 4 Tablespoons of liquid dish detergent in a bucket of water. …
- Vinegar and water. If you don’t care for either bleach or detergent, vinegar can be your go-to. …
- Clean that mask.
Can you put snorkel gear in the dishwasher?
The Snorkel
Most snorkels can be cleaned in a dishwasher. It’s probably best to remove the clip that attaches to the snorkel mask since it could loose it’s flexibility. Place it in the upper compartment of your dishwasher and generally you should be fine.
How do you disinfect a scuba mask?
Use a small blob of regular white toothpaste (not gel), get comfy and rub that stuff around and around your mask. Take a short break, then get rubbing again. Put a good movie on and keep going, yes it’s tedious! You could use a cloth, or an old toothbrush too.
How do you get mold out of scuba gear?
Fill up a barrel with water and mild soap and do a good old fashioned hand wash, sloshing it in and out of the water. Rinse and dry. Repeat if necessary. Use a toothbrush and soap solution for the mouthpieces.
How do you clean scuba diving equipment?
Rinse your mask, fins and snorkel after every use and allow them to dry completely before storing to avoid mildew growth. Use fresh, clean water and rotate any moving parts to remove salt, sand or other debris. Sanitize snorkel mouthpieces the same way you would regulator mouthpieces.