How do you set up a jib sail?
Set the jib leads as far aft as possible with the luff of the sail breaking evenly. If the top of the sail breaks first, move the lead forward; if the bottom of the sail breaks first, move the lead aft. Finally, trim the sail so the leech tell tales are not flowing, then ease the sheet until they start to flow.
What is the first step when rigging the jib?
Rigging the boat – the jib
Always start with the jib (smaller sail). Determine top, front (with the ticklers which are red and green ribbons) and back of the sail. 2. Attach the jib halyard shackle to the top of the jib and make sure it isn’t twisted up in the block.
What part of the sail do you attach first when rigging the jib?
First, spread out the sail and identify each of its corners. The “head” is the top of the sail, where the triangle is the most narrow. Attach the jib halyard shackle to this corner, making sure the shackle is closed and secure. Then follow the front edge of the sail (called the “luff”) down to the next corner.
What is the difference between a jib and a genoa?
Colloquially the term is sometimes used interchangeably with jib. A working jib is no larger than the 100% foretriangle. A genoa is larger, with the leech going past the mast and overlapping the mainsail. … Working jibs are also defined by the same measure, typically 100% or less of the foretriangle.
How long should my jib sheets be?
The rule of thumb with jib sheets is 1.5 times the boat length. Jib sheet length is governed by the lazy sheet, which needs to be long enough to reach the lazy winch with slack, and have a bit to spare.
What are Hanks on a sail?
Piston hanks and jib hanks are used for sail attachment. Traditionally, hanks consist of a short piece of rope spliced or sewn into or around the bolt rope, but can also be made of wire. For staysails like jib sails and other sail types, in traditional sailing forged metal hanks or jib hank shackles are often used.
How is a mast attached to a sailboat?
Rigging. The rigging is what is used to attach your sails and mast to your boat. Rigging, in other words, mostly consists of all kinds of lines.
What is the topping lift on a sailboat?
The topping lift (more rarely known as an uphaul) is a line which applies upward force on a boom on a sailboat. Part of the running rigging, topping lifts are primarily used to hold a boom up when the sail is lowered. This line would run from near the free end of the boom(s) forward to the top of the mast.
How do you rig a furling jib?
Furling the jib can be done by tying off the head on a anchor point then tensioning the luff by tying off the tack. Options may be between two people, rigging the sail as if it were a normal jib, between two posts etc You then just wrap the clew around the jib tightly until it is furled away and tie it off.
What does trim the jib mean?
Jib Sheet. Trimming the sheet affects the twist in the headsail and also the overall power. By trimming the sail on more you decrease the twist and power up the sail to allow you to point higher. Easing the sheet has the opposite effect – more speed and less pointing ability.
How do you attach a jib sheet to a soft shackle?
To use a soft shackle, you thread one end through or around the objects that you want to shackle together and then thread the knot through the eye like a button in a buttonhole.