Telltales should be positioned on the leech at each batten; usually it takes 4. In the center of the main a little forward of center you will place a pair much in the same way you attached the ones one the jib. Put them between the first and second battens and between the second and third battens, again avoiding seams.
How do you use a telltale on a sail?
Telltales are pieces of yarn or sailcloth near the luff of the sail. – If the windward (closest to the direction from which the wind is coming) telltale is fluttering, either sheet in the jib toward the telltale or turn the boat away from the telltale (bear away) until it stops fluttering and flows smoothly.
Where is the clew on a sail?
The corner where the leech and foot connect is called the clew on a fore-and-aft sail. On a jib, the sheet is connected to the clew; on a mainsail, the sheet is connected to the boom (if present) near the clew. Clews are the lower two corners of a square sail.
Where do you put a telltale on a jib?
Telltales should be positioned on the leech at each batten; usually it takes 4. In the center of the main a little forward of center you will place a pair much in the same way you attached the ones one the jib. Put them between the first and second battens and between the second and third battens, again avoiding seams.
Where do I put telltales on Genoa?
Genoa. Telltales are placed on both sides of the sail, at a minimum in rows at about, and hoist, the lowest of which must be visible to the helmsman from any position. Avoid seams, since the telltale can hang-up. At a minimum, telltales will be placed 12 inches aft of the luff and way between the leach and luff.
What is a roach in sailing?
Roach is a term also applied to square sail design—it is the arc of a circle above a straight line from clew to clew at the foot of a square sail, from which sail material is omitted. The greater the departure from the straight line, the greater the “hollow” in the roach.
What are the strings on sails for?
A tell-tale, also known as a tell-tail, in a nautical or sailing context, is a piece of yarn or fabric attached to a sail, a stay, or any rigging on a sailboat. Typically, a tell-tail is on a port and a starboard stay. Tell-tales attached to a sail are used as a guide for trimming (adjusting) a sail.
What are the sheets in sailing?
Sailboat Sheets and Guys are ropes or lines that are used to trim a sail. Sheets are attached directly to the clew of most sails, the exception being the mainsail.
What is the Outhaul on a sailboat?
An outhaul is a control line found on a sailboat. It is an element of the running rigging, used to attach the mainsail clew to the boom and tensions the foot of the sail. It commonly uses a block at the boom end and a cleat on the boom, closer to the mast, to secure the line.
How do you use a leech in Telltale?
Telltales can be used on the leech to indicate flow on a non-overlapping jib. As usual, it is the top telltale that counts. Usually there is only a single telltale in the upper 25% of the leech. Trim too hard or pull the lead too far down (or too far forward) for conditions and that telltale will stall.
Where should tell tales be installed underground?
Telltales are being installed in each junction and roadway midpoint prior to extraction operations. The telltales used are single height types with the anchor position at 10m into the roof and a trigger level of 5mm.
How do you read ticklers?
The most basic way to read telltales is to get the yarns on both sides of the sail streaming straight back. If the leeward one stops streaming, head up and sail closer to the wind. If the windward one stops streaming, fall off.
What telltale means?
Definition of telltale
1a : an outward sign : indication. b : talebearer, informer. 2 : a device for indicating or recording something: such as. a : a wind-direction indicator often in the form of a ribbon. b : a strip of metal on the front wall of a racquets or squash court above which the ball must be hit.